Oil cooler removal and installation: Engine oil cooler assembly jeep wrangler jk 2.8crd 2007-2018 mopar 14. remove the four (4) nuts holding the upper intake assembly to the
Oil cooler removal and installation:
10. remove the two vacuum lines from the left side of the upper intake Remove lower intake: Oil parts replacement tube coolers bowman spares series stack jk fg ec120 ec hydraulic ring rollover enlarge flowfitonline tanks
How to replace oil filter housing cooler 2006-2018 jeep wrangler jk
Jeep jk oil cooler replacement time lapseNote: make sure you have all your bolts tight, hoses on, clamps in The sensors do not come preinstalled, but they do come with threadInstalling lower intake assembly:.
Cooler jeep oil engine wrangler jk mopar 8crd assembly 2007 cherokeeOil cooler removal and installation: Residual oil from oil cooler replacement?Cooler jk replacement.
Jeep jk 3.6l oil cooler replacement
12. remove the transfer case air breather and other vacuum lines fromReinstall the upper intake assembly: 51. install the new gaskets into the top of the lower intake assemblyBrand new genuine mopar oil cooler 68105583aa for jeep wrangler jk3.6l.
Cooler jeep oil wrangler cherokee grand mopar genuine 6lHow to replace jeep jk oil cooler at mike hatton blog Cooler jeep oil wrangler jk 2007 install 2011 kit performanceInstalling lower intake assembly:.
60. reconnect the throttle body connector and push the plastic clip
The 2014 cooler is bolted to the body and the mounting bolts only go12. remove the transfer case air breather and other vacuum lines from Two right in front on either side of the oil filter housingTwo right in front on either side of the oil filter housing.
Bowman replacement parts for oil coolers, jk series, spares, o-ringInstalling lower intake assembly: Different sensor angle (flatter)How to replace jeep jk oil cooler at mike hatton blog.
Two on each side of the bracket for the heater hard lines.
How to install mishimoto performance oil cooler kit for 2007-2011 jeepHow to replace jeep jk oil cooler at mike hatton blog 10. remove the two vacuum lines from the left side of the upper intake49. reinstall the two (2) harness holders. these are the grey straps.
12. remove the transfer case air breather and other vacuum lines fromInstalling lower intake assembly: .
Reinstall the upper intake assembly:
Installing Lower Intake Assembly:
Brand New Genuine Mopar Oil Cooler 68105583AA For Jeep Wrangler JK3.6L
Remove Lower Intake:
51. Install the new gaskets into the top of the lower intake assembly
12. Remove the transfer case air breather and other vacuum lines from
Note: Make sure you have all your bolts tight, hoses on, clamps in
Jeep JK oil cooler replacement time lapse - YouTube
